Yealink SIP-T2 Series - Page 313

Configuring Basic Features
289
Parameters
Permitted Values
Default
Settings->Dial Plan->Area Code->Max Length (1-15)
Phone User Interface:
None
dialplan.area_code.line_id
Refer to the following content
Blank (for
all lines)
Description:
Configures the desired line to apply the area code rule. The digit 0 stands for all lines. If it is
left blank, the area code rule will apply to all lines on the IP phone.
Permitted Values:
0 to 16 (for SIP-T48G/T48S/T46G/T46S/T29G)
0 to 12 (for SIP-T42G/S)
0 to 6 (for SIP-T41P/T41S/T27P/T27G)
0 to 3 (for SIP-T40P/T40G/T23P/T23G)
0 to 2 (for SIP-T21(P) E2)
Example:
dialplan.area_code.line_id = 1
Note: Multiple line IDs are separated by commas. It is not applicable to SIP-T19(P) E2 IP
phones. It works only if the values of the parameters “dialplan.digitmap.enable” and
“account.X.dialplan.digitmap.enable” are set to 0 (Disabled).
Web User Interface:
Settings->Dial Plan->Area Code->Account
Phone User Interface:
None
To configure an area code rule via web user interface:
1. Click on Settings->Dial Plan->Area Code.
2. Enter the desired values in the Code, Min Length (1-15) and Max Length (1-15) fields.
3. Enter the desired line ID in the Account field or leave it blank.