Valid values are:
Single configuration (configure a specific value for the timer letter “T” for all strings
with “T” of the digit map)
Example:
dialplan.digitmap.interdigit_short_timer = 5
If the value of the parameter “dialplan.digitmap.string” is set to <[2-9]x:86>3.T|0T, the
IP phone will wait 5 seconds before matching the entered digits to this dial plan and
placing the call.
Distribution configuration (configure a string of positive integers separated by “|” for
each string of the digit map in the corresponding position)
If there are more digit maps than timeout values, the last timeout is applied to the
extra digit map. If there are more timeout values than digit maps, the extra timeout
values are ignored.
Example:
dialplan.digitmap.interdigit_short_timer = 4|5|3|6|2|1
If the value of the parameter “dialplan.digitmap.string” is set to
<[2-9]x:86>3.T|2T|1xxT|0x.!|[2-9]11T, 4 is applied to the “<[2-9]x:86>3.T” digit map, 5 is
applied to “2T” digit map, 3 is applied to “1xxT” digit map, 6 is applied to “0x.!” digit
map, 2 is applied to the “[2-9]11T” digit map, the last digit 1 is ignored.
Note: It works only if the value of the parameter “dialplan.digitmap.enable” or
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.interdigit_short_timer” takes precedence over that
configured by this parameter.
Web User Interface:
None
Phone User Interface:
None
Description:
Configures the behavior when an impossible digit map match occurs.
0-prevent users from entering a number and immediately dial out the entered numbers
1-the dialing will fail and the LCD screen will prompt “Forbidden Number”
2-allow users to accumulate digits and dispatch call manually with the send key or
automatically dial out the entered number after a certain period of time configured by the
parameter “dialplan.digitmap.interdigit_long_timer”
Note: It works only if the value of the parameter “dialplan.digitmap.enable” or
To Next Page
Loading...
Need help?
General
