Yealink SIP-T2 Series

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
298
Parameters
Permitted
Values
Default
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.no_match_action” takes precedence over that
configured by this parameter.
Web User Interface:
None
Phone User Interface:
None
dialplan.digitmap.active.on_hook_dialing
0 or 1
0
Description:
Enables or disables the entered numbers to match the predefined string of the digit map in
real time. It is only applicable to the on-hook dialing.
0-Disabled
1-Enabled
Note: It works only if the value of the parameter “dialplan.digitmap.enable” or
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.active.on_hook_dialing” takes precedence over that
configured by this parameter.
Web User Interface:
None
Phone User Interface:
None
dialplan.digitmap.apply_to.on_hook_dial
0 or 1
1
Description:
Enables or disables the entered number to match the predefined string of the digit map
after pressing a send key when dialing on-hook or pressing the DSS key (e.g., speed dial, BLF
or prefix key).
0-Disabled
1-Enabled
Note: It works only if the value of the parameter “dialplan.digitmap.enable” or
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.apply_to.on_hook_dial” takes precedence over that
configured by this parameter.
Web User Interface:
None