Yealink SIP-T2 Series - Page 437

Configuring Basic Features
413
Parameters
Permitted Values
Default
X is equal to 1 (for SIP-T19(P) E2)
Note: It works only if the value of the parameter “sip.rfc2543_hold” is set to 0 (Disabled).
Web User Interface:
None
Phone User Interface:
None
To configure call hold tone and call hold tone delay via web user interface:
1. Click on Features->General Information.
2. Select the desired value from the pull-down list of Play Hold Tone.
3. Enter the desired time in the Play Hold Tone Delay field.
4. Click Confirm to accept the change.
To configure call hold method via web user interface:
1. Click on Features->General Information.