Yealink SIP-T2 Series User Manual

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
652
Parameters
Permitted Values
Default
multicast address on the channel 26 to 30 respectively from Yealink IP phones.
Example:
multicast.listen_address.1.channel = 2
Web User Interface:
Directory->Multicast IP->Multicast Listening->Channel
Phone User Interface:
None
multicast.listen_address.X.volume
(X ranges from 1 to 31)
Integer from 0 to 15
0
Description:
Configures the volume of the speaker when receiving the multicast paging calls.
If it is set to 0, the current volume of the speaker takes effect. The volume of the speaker
can be adjusted by pressing the Volume key in advance when the phone is during a call.
You can also adjust the volume of the speaker during the paging call.
If it is set to 1 to 15, the configured volume takes effect and the current volume of the
speaker will be ignored. You are not allowed to adjust the volume of the speaker during the
paging call.
Example:
multicast.listen_address.1.volume = 1
Web User Interface:
None
Phone User Interface:
None
multicast.receive.use_speaker
0 or 1
0
Description:
Enables or disables the IP phone to always use the speaker as the audio device when
receiving the multicast paging calls.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), the engaged audio device will be used when receiving the
multicast paging calls.
Web User Interface:
None
Phone User Interface:

Yealink SIP-T2 Series Specifications

General

Brand	Yealink
Model	SIP-T2 Series
Category	IP Phone
Language	English