Yealink SIP-T2 Series - Page 75

Setting Up Your System
51
Half-duplex
Half-duplex transmission refers to transmitting voice or data in both directions, but in one
direction at a time; this means one device can send data on the line, but not receive data
simultaneously. You can configure the half-duplex transmission on both Internet port and PC
port for the IP phone to transmit in 10Mbps or 100Mbps.
Full-duplex
Full-duplex transmission refers to transmitting voice or data in both directions at the same time;
this means one device can send data on the line while receiving data. You can configure the
full-duplex transmission on both Internet port and PC port for the IP phone to transmit in
10Mbps, 100Mbps or 1000Mbps (1000Mbps is only applicable to
SIP-T48G/T48S/T46G/T46S/T42G/T42S/T40G/T29G/T27G/T23G IP phones).
Procedure
The transmission methods of Ethernet ports can be configured using the following methods.
Central Provisioning
(Configuration File)
<y0000000000xx>.c
fg
Configure the transmission methods of the
Ethernet ports.
Parameters:
static.network.internet_port.speed_duplex
static.network.pc_port.speed_duplex