Yealink SIP-T2 Series User Manual

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
52
Web User Interface
Configure the transmission methods of the
Ethernet ports.
Navigate to:
http://<phoneIPAddress>/servlet?p=networ
k-adv&q=load
Details of Configuration Parameters:
Parameters
Permitted Values
Default
static.network.internet_port.speed_duplex
0, 1, 2, 3, 4 or 5
0
Description:
Configures the transmission method of the Internet port.
0-Auto Negotiation
1-Full Duplex 10Mbps
2-Full Duplex 100Mbps
3-Half Duplex 10Mbps
4-Half Duplex 100Mbps
5-Full Duplex 1000Mbps (only applicable to
SIP-T48G/T48S/T46G/T46S/T42G/T42S/T40G/T29G/T27G/T23G IP phones)
Note: For SIP-T48G/T48S/T46G/T46S/T42G/T42S/T40G/T29G/T27G/T23G IP phones, you
can set the transmission speed to 1000Mbps/Auto Negotiation to transmit in 1000Mbps if
the IP phone is connected to the switch supports Gigabit Ethernet. We recommend that you
do not change this parameter. If you change this parameter, the IP phone will reboot to
make the change take effect.
Web User Interface:
Network->Advanced->Port Link->WAN Port Link
Phone User Interface:
None
static.network.pc_port.speed_duplex
0, 1, 2, 3, 4 or 5
0
Description:
Configures the transmission method of the PC port.
0-Auto Negotiation
1-Full Duplex 10Mbps
2-Full Duplex 100Mbps
3-Half Duplex 10Mbps
4-Half Duplex 100Mbps

Yealink SIP-T2 Series Specifications

General

Brand	Yealink
Model	SIP-T2 Series
Category	IP Phone
Language	English