Yealink SIP-T2 Series User Manual

Setting Up Your System
53
Parameters
Permitted Values
Default
5-Full Duplex 1000Mbps (only applicable to
SIP-T48G/T48S/T46G/T46S/T42G/T42S/T40G/T29G/T27G/T23G IP phones)
Note: It works only if the value of the parameter “static.network.pc_port.enable” is set to 1
(Auto Negotiation). For SIP-T48G/T48S/T46G/T46S/T42G/T42S/T40G/T29G/T27G/T23G IP
phones, you can set the transmission speed to 1000Mbps/Auto Negotiation to transmit in
1000Mbps if the IP phone is connected to the switch supports Gigabit Ethernet. We
recommend that you do not change this parameter. If you change this parameter, the IP
phone will reboot to make the change take effect.
Web User Interface:
Network->Advanced->Port Link->PC Port Link
Phone User Interface:
None
To configure the transmission methods of Ethernet ports via web user interface:
1. Click on Network->Advanced.
2. Select the desired value from the pull-down list of WAN Port Link.
3. Select the desired value from the pull-down list of PC Port Link.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
5. Click OK to reboot the phone.

Yealink SIP-T2 Series Specifications

General

Brand	Yealink
Model	SIP-T2 Series
Category	IP Phone
Language	English