YOKOGAWA AQ7280 - Setting the Data Save Conditions; Switching the Display

5-7
IM AQ7280-01EN
Optical Output and Optical Power Measurement
1
2
3
4
5
6
7
8
Index
Switching the Display
You can select from two screen displays.
Core List: A list of core numbers and save areas is displayed. An example is shown on the
previous page.
List: Only a list of save areas is displayed.
• When the Display is set to List
Core number
Save area of core number 1
Measured data
(measurement conditions and measured values)
Same as the screen of the core number list.
Setting the Data Save Conditions
1.
From the top menu, select Power Meter to display the Power Meter menu.
2.
Press SETUP and then the Save Data soft key to display the following screen.
Set the starting core number (1 to 9900).
Set the number of cores or tapes
(1 to 100).
Set the tape number
(OFF, a-b(2), a-c(3), a-d(4), a-e(5), a-f(6),
a-g(7), a-h(8)).
Tape no. Type
By setting the tape number type, you can the tape number accordingly.
The core number display will be as follows.
OFF: 1, 2, 3, ...
a-d(4): 1a, 1b, 1c, 1d, 2a, 2b, 2c, 2d, 3a, 3b, 3c, 3d, ...
Cable
How tape No. a-d(4) are used
Core 1a, 1b, 1c, 1d
5.2 Measuring Optical Power (OPM, /PC option)