YOKOGAWA AQ7280 - Operation Lock Setup Screen; Setting Operation Restrictions

7-3
IM AQ7280-01EN
System Configuration
1
2
3
4
5
6
7
8
Index
7.3 Setting Operation Restrictions
Procedure
Operation Lock Setup Screen
1.
Press SETUP and then the System Setup soft key.
2.
Using the rotary knob and ENTER, select Operation Lock Setup to display the following
screen.
Enter the Administrator PIN.
The default value is 0000.
Confirms the input
Change the Administrator PIN.
Setting Operation Restrictions
Using the rotary knob and ENTER, enter the PIN, and then select SET. The following screen
appears.
Select the restriction mode.
• No Check
Operation possible without entering the PIN.
• Check only once
Enter the PIN only for the first operation.
• Check everytime
Enter the PIN for every operation.
Enter the old PIN (the default value is 0000).
Enter the new PIN.
Enter the new PIN again for confirmation.
Confirms the input
Changing the Administrator PIN
Using the rotary knob and ENTER, select Change Administrator PIN to display the following
screen.
Enter the old PIN
(the default value is 0000).
Enter the new PIN.
Enter the new PIN again for
confirmation.
Confirms the input
Initializing the PIN
When you change the setting, both the administrator PIN and user PIN will be initialized. For details,
see section 7.2.