App-5
IM WT18
O
1E-02EN
Code Message Chapter or Section
890 Cannot start the store.
Change store mode from synchronize with integration or set store interval to zero by
the [STORE SET] menu.
Otherwise, turn off Auto of the Data Update Interval by the [UPDATE RATE] menu.
16.1 or 1.15
891 Cannot start the auto print.
Change print mode from sychronize with integration by the [STORE SET] menu.
Otherwise, turn off Auto of the Data Update Interval by the [UPDATE RATE] menu.
19.2 or 1.15
892 Cannot start the integration.
Set S and Q Formula to another expecting for Type 3 by the [MEASURE] menu, or fix
measurement ranges.
7.3, 1.2, or 1.3
System Error Messages (900 to 999)
Code Message Chapter or Section
901 Failed to backup setup data.
The system has been initialized.
Maintenance service is required.
—
902 System RAM failure.
Maintenance service is required.
—
903 System ROM failure.
Maintenance service is required.
—
905 System failure.
Install the input modules and the options correctly.
—
906 Fan stopped.
Power off immediately.
Maintenance service is required.
—
907 Backup battery is flat.
Maintenance service is required to replace the back-up battery.
—
909 Illegal SUM value.
Maintenance service is required.
—
910 This operation is prohibited for EEPROM protection. —
915 EEPROM SUM error.
EEPROM may be damaged.
Maintenance service is required.
—
919 Module installation condition and setup parameters do not match.
The system has been initialized.
Maintenance service is required.
—
920 SUM error of NULL value.
The Null value is reset to 0.
—
921 System Failed to Draw Display.
Maintenance service is required.
—
922 Failed in communication with devices.
Maintenance service is required.
—
923 Transmit data abnormality from devices.
Maintenance service is required.
—
926 The USB device’s power consumption exceeded the capacity of the USB hub. —
927 Disconnected USB device port 1, because overcurrent was detected. —
928 Disconnected USB device port 2, because overcurrent was detected. —
929 A USB mass storage device that is greater than 137 GB in capacity has been
connected.
Be careful in using this device.
If an area exceeding 137 GB is accessed, the storage device may break.
—
931 Hardware configuration error occurred. Restart this machine.
If it occurred again, maintenance service is required.
—
932 Error occurred while ImageFile process. —
Appendix 1 Messages and Corrective Actions
To Next Page
Loading...
