VIEWING OEM ENHANCED DTCs (Ford/Mazda only)
For technical questions, please call 1-888-866-5797.
13
n If KOER is selected, an advisory message shows.
- Start and warm the engine to normal operating temperature,
then choose Continue. Proceed to step 3.
2. If KOEO or Continuous Memory is selected, an “instructional”
message shows.
n Turn the ignition OFF, then back ON. Choose Continue. Proceed
to step 3.
3. A “One moment please” message displays while the test is in
progress.
n If the Scan Tool fails to link to the vehicle’s computer, a
“Communication Error” message shows.
- Ensure your vehicle is OBD2 compliant.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Choose Relink to try again, or, choose System Menu to return
to the System Menu.
n If the Scan Tool cannot link to the vehicle’s computer after three
attempts, the message “Contact Technical Support” displays.
- Choose System Menu to return to the System Menu.
- Turn the ignition off, and disconnect the Scan Tool.
- Contact Technical Support for assistance.
n If the KOER Test was selected, and the vehicle’s engine is not
running, an advisory message shows.
- Start the engine and choose Relink to try again, or, choose
System Menu to return to the System Menu.
n If the KOEO Test was selected, and the vehicle’s engine is
running, an advisory message shows.
- Turn the ignition OFF then back ON and choose Relink to try
again, or, choose System Menu to return to the System Menu.
4. If the KOER test was selected, an “instructional” message shows.
n Turn the steering wheel to the right, then release.
n Press and release the brake pedal.
n Cycle the overdrive switch (if equipped).
n A “One moment please” message displays while the test is in
progress.
5. Refer to DISPLAY FUNCTIONS on page 3 for a description of LCD
display elements.
If the definition for the currently displayed code is not
available, an advisory message shows.
To Next Page
Loading...
Need help?
General
