THE SYSTEM MENU / VIEWING OEM ENHANCED DTCs (except Ford/Mazda)
For technical questions, please call 1-888-866-5797.
11
n To prolong battery life, the Scan Tool automatically shuts “Off”
approximately three minutes after it is disconnected from the
vehicle. The DTCs retrieved, Monitor Status and Freeze Frame
data (if any) will remain in the Scan Tool’s memory, and may be
viewed at any time by turning the unit “On”. If the Scan Tool’s
batteries are removed, or if the Scan Tool is re-linked to a vehicle
to retrieve codes/data, any prior codes/data in its memory are
automatically cleared.
THE SYSTEM MENU
The System Menu provides the ability to retrieve “enhanced” DTCs, Anti-Lock
Brake System (ABS) and Supplemental Restraint System (SRS) DTCs for
most BMW, Chrysler/Jeep, Ford/Mazda, GM/Isuzu, Honda/Acura, Hyundai,
Mercedes Benz, Nissan, Toyota/Lexus, Volkswagen and Volvo vehicles. The
types of enhanced data available depends on the vehicle make. You can also
return to the Global OBD2 mode.
Depending on the vehicle under test, some features and functions
may not be available.
n To access the System Menu, press
SYSTEM MENU . Select the desired
option, then press ENTER to view
the selected information.
To view ABS DTCs: Select ABS. Refer to
VIEWING ABS DTCs on page 14 to view
ABS DTCs for your vehicle.
To view SRS DTCs: Select SRS. Refer to VIEWING SRS DTCs on page
15 to view SRS DTCs for your vehicle.
To view OEM enhanced DTCs: Select OEM Enhanced. Refer to
VIEWING OEM ENHANCED DTCs on page 11 to view OEM enhanced
DTCs for your vehicle.
To perform a Network Test: Select Scan all Modules or Select
Modules, as desired. Refer to NETWORK TEST on page 16 to view
DTCs for other modules.
VIEWING OEM ENHANCED DTCs (except Ford/Mazda)
When (make) OEM Enhanced is chosen from the System Menu, the
Scan Tool retrieves OEM enhanced DTCs from the vehicle’s computer.
1. A “One moment please” message displays while the Scan Tool
retrieves the selected DTCs.
n If the Scan Tool fails to link to the vehicle’s computer, a
“Communication Error” message shows.
- Ensure your vehicle is OBD2 compliant.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Choose Relink to try again, or, choose System Menu to return
to the System Menu.
To Next Page
Loading...
Need help?
General
