SYSTEM/ACTUATOR TESTS
For technical questions, please call 1-888-866-5797.
43
1. Select Injector Kill System Test in the Special Functions menu, then
press ENTER .
n An “instructional” screen displays. Prepare the vehicle for test as
directed.
- Start and idle the engine.
- Make sure engine coolant temperature is 83°C (180°F) before
proceeding.
2. Choose Yes to continue.
n A “status” screen displays while a vehicle status check is
performed.
n The Select Injector screen displays.
3. Select the desired injector, then press ENTER .
n The test results screen displays.
n The screen shows the Injector Kill
Routine Results and the current
Engine Speed.
4. If desired, choose Reselect to return to
the Select Injector screen, and repeat
step 3 to select a new fuel injector.
5. Choose Finish to return to the Special
Functions menu.
Injector Kill System Test (002)
The Injector Kill System Test function lets you perform a test of the
injector kill system for a selected fuel injector.
1. Select Injector Kill System Test in the Special Functions menu, then
press ENTER .
n An “instructional” screen displays. Prepare the vehicle for test as
directed.
- Start and idle the engine.
- Make sure engine coolant temperature is 83°C (180°F) before
proceeding.
2. Choose Yes to continue.
n A “status” screen displays while a
vehicle status check is performed.
n The Select Injector screen displays.
3. Select the desired injector, then press
ENTER .
n The test results screen displays.
To Next Page
Loading...