VIEWING SRS DTCs
For technical questions, please call 1-888-866-5797.
15
- Choose Relink to try again, or, choose System Menu to return
to the System Menu.
n If the Scan Tool cannot link to the vehicle’s computer after three
attempts, the message “Contact Technical Support” displays.
- Choose System Menu to return to the System Menu.
- Turn the ignition off, and disconnect the Scan Tool.
- Contact Technical Support for assistance.
2. Refer to DISPLAY FUNCTIONS on page 3 for a description of LCD
display elements.
If the definition for the currently
displayed code is not available, an
advisory message shows.
I/M MONITOR STATUS icons are
not displayed when viewing ABS
DTCs.
In the case of long code definitions, a small arrow is shown in
the upper/lower right-hand corner of the code display area to
indicate the presence of additional information.
n If no codes are present, the message "No ABS DTC’s are
presently stored in the vehicle’s computer" shows. Choose
System Menu to return to the System Menu.
3. If more than one code was retrieved press DTC/FF to display
additional codes one at a time.
n Whenever the Scroll function is used, the Scan Tool’s
communication link with the vehicle’s computer disconnects. To
re-establish communication, press POWER/LINK again.
4. When the last retrieved DTC has been displayed and DTC/FF is pressed,
the Scan Tool returns to the “Priority” Code.
n To exit the enhanced mode, choose System Menu button to
return to the System Menu. Select Global OBD, then press
ENTER to return to the Global OBD2 mode.
VIEWING SRS DTCs
Refer to the manufacturer’s website for vehicle makes covered.
1. When SRS DTCs is chosen from the System Menu, a "One moment
please" message displays while the Scan Tool retrieves the selected
DTCs.
n If SRS functionality is not supported, an advisory message shows.
Press SYSTEM MENU to return to the System Menu.
To Next Page
Loading...
Need help?
General
