ACF5000 FTIR ANALYZER SYSTEM | OI/ACF5000-EN REV. A 109
Active component selection
Menu path
MENU → Configure → Component-specific → Active Component
Active component
With this FID analyzer module, several measured components can be config-
ured however, only one measured component is measured and displayed.
Procedure
Select the active component with the arrow keys and press ENTER to con-
firm.
Subsequently, use the "Measuring range" menu item to select the range for
the desired active component.
NOTICE
The selected active component and measuring range are shown on the
screen after switching to measurement mode.
To Next Page
Loading...
