To Next Page

To Previous Page

ACF5000 FTIR ANALYZER SYSTEM | OI/ACF5000-EN REV. A 141

Configuring key entries

1 Select Display menu item.

2 Start configuration of the new display element with NEW.

3 Select the Page parameter.

The page overview is displayed.

4 Select the page on which the display element is to be displayed. Only

those pages can be selected with an assignment < 100%, i.e. in which

there is at least one free position.

If the selected page is a system page, the position of the display ele-

ment is set by the system; it can only be changed using Swap Display

(see page 136).

If the new page is a user page, the position must be configured.

5 Select the Position parameter.

The nine possible positions are graphically represented; free positions

are identified by the position number.

6 Select the position with the corresponding number key.

7 Select the Type parameter.

8 Select the display type Keys.

This creates a single function block Constant, whose system default

name 'Value page-position' is displayed in the parameter Source. This

name does not appear in the display. If necessary, it can be changed by

configuring the function block (see step 11).

9 Select the Config keys parameter and configure the other parameters:

key number, key type, label, value released/pressed, text and password

level. If all the keys are configured individually, a separate Constant

function block is created for each key.

10 The description of the display element is entered in the Test point

parameter.

11 Select each of the function blocks created in steps 8 and 9 and link to an

application with its output 1 (see Technical Information "Function blocks

– Descriptions and configuration" for detailed description).

12 Switch to measuring mode.

The newly configured display element is now shown in the display. The

description of the display element is shown above the display.

ABB ACF5000 User Manual

Questions and Answers: