ABB ACF5000 - Operating by key entry; Key entry

60 ACF5000 FTIR ANALYZER SYSTEM | OI/ACF5000-EN REV. A
Operating by key entry
Key entry
Key entries are made in measurement mode by pressing the appropriate
number key that corresponds to the position of the display element on the
display and that is indicated over the display element.
In the example, this is key 4:
A softkey line then appears with the configured keys:
Description and configuration
Further information about pressure correction can be found in sections "Key
entry" (see page 140) and "Configuring key entries" (see page 141).