198 ACF5000 FTIR ANALYZER SYSTEM | OI/ACF5000-EN REV. A
K
Key entry • 51, 60, 133, 140
M
Maintenance • 142
Maintenance switch • 149
Manual adjustment • 69
Manual start of automatic adjustment • 70, 101
Material required for the installation (not
supplied) • 31, 35, 42, 45
Menu structure • 66
Message display • 52
Monitoring the internal cabinet temperature •
151
Moving a display element from one page to
another • 135
Moving a display element within a page • 136,
137, 139, 141
N
Notify service • 194
Numeric keypad • 50, 54
O
Operating by key entry • 60, 140
Operating by value input • 59, 138
Operating gases and test gases • 25, 42, 47
Operating the analyzer system • 64
Operation • 50
Output current response • 91
P
Packing the analyzer cabinet • 195
Page overview • 130, 131, 132
Parameter overview • 130, 131, 133
Password protection • 61, 65, 116, 179
Power supply • 27, 46
Preface • 6
Preparation for installation • 20
Process status • 174
R
Recommissioning • 47
Replace system module • 121
Replacing filter cells in air purifier AU5 • 161, 168
Replacing filter in the compressed air main
regulator (-J85) • 161, 166
Replacing filter on the gas sampling probe • 161,
162
Replacing filter pad in the fan • 161, 169
Replacing filters in the sample gas pressure
regulator • 161, 167
Replacing pressure equalization screws • 161, 171
Replacing sample gas filter in the ASP block • 161,
164
Replacing the battery on the system controller •
161, 170
Replacing wearing parts • 161
Requirements for the installation site of the
analyzer cabinet • 22, 34, 35
S
Safety instructions • 8, 142
Safety instructions for handling the analyzer
system • 10, 142
Safety instructions for handling the analyzer
system with integrated FID • 10, 11, 43, 142
Safety instructions for handling the FTIR
spectrometer • 10, 12, 142
Safety instructions for working with poisonous
gases • 10, 13, 142
Sample gas inlet conditions • 24
Save configuration • 123
Saving the reference as an initial reference • 97
Scope of supply and delivery • 30, 33
Seal integrity test • 145, 163, 165
Selecting user interface language • 113, 115
Selection of the sampling point, installation of
the wall tube • 20
Setting system modules • 118, 129
Setting time zone, date and time • 114
Shutting down the analyzer system • 195
Softkeys • 50, 51, 56
Start Automatic Adjustment Check (AAC)
manually • 98
Status LEDs • 50, 53
Status message categories • 177
Status message system • 157, 179, 193
Status messages FTIR • 187
Status messages, troubleshooting • 53, 56, 172
Switch measuring range • 102
System status
Status messages • 174, 175
Status signals • 124, 176
T
Text entry • 54, 58, 113
U
User page configuration • 130, 132, 134
V
Value input • 51, 59, 133, 138
Visual inspection • 143
To Next Page
Loading...
Need help?
General
