￭
Control panel LEDs
The assistant control panel has one LED. The table below describes the control
panel LED indications. For more information see ACS-AP-I, -S, -W and ACH-AP-H,
-W Assistant control panels user’s manual (3AUA0000085685 [English]).
Control panel LED, at the left edge of the control panel
LED blinking/flickeringLED lit and steadyLED off
Blinking:
Active warning in the drive
Flickering:
Data transferred between the
PC tool and drive through the
USB connection of the control
panel
GreenDrive functioning normally.
Connection between the drive
and control panel may be faulty
or lost, or the panel and drive
may be incompatible. Check
the control panel display.
GreenPanel
has no
power
Active fault in the drive.
To reset the fault, cycle the
drive power.
RedCheck the display to see where
the fault is.
Red
• Active fault in the drive.
Reset the fault.
• Active fault in another drive
in the panel bus.
Switch to the drive in ques-
tion and check and reset
the fault.
Panels with a Bluetooth inter-
face only.
Blinking:
Bluetooth interface is enabled.
It is in discoverable mode and
ready for pairing.
Flickering:
Data is transfered through the
Bluetooth interface of the
control panel.
Blue
Maintenance 263
To Next Page
Loading...
