Electromagnetic compatibility (EMC) – Limits for harmonic
current emissions (input current > 16 A per phase)
IEC 61000-3-2:2018,
EN 61000-3-2:2014
Electromagnetic compatibility (EMC) – Limits for harmonic
currents produced by equipment connected to public low-
voltage systems with input current input current > 16 A and <
75 A per phase
EN 61000-3-12:2011
This drive complies with the standard provided that the short-
circuit power Ssc is greater than or equal to the minimum short-
circuit power given for the drive (listed for each drive type on
page 344) at the interface point between the user's supply and
the public system. It is the responsibility of the installer or user
of the drive to ensure, by consultation with the distribution
network operator if necessary, that the drive is connected only
to a supply with a short-circuit power Ssc greater than or equal
to the minimum short-circuit power given for the drive.
Adjustable speed electrical power drive systems. Part 3: EMC
requirements and specific test methods
IEC/EN 61800-3:2017
Adjustable speed electrical power drive systems. Part 5-1: Safety
requirements – electrical, thermal and energy
IEC/EN 61800-5-1:2007
Adjustable speed electrical power drive systems. Part 9-2: Eco-
design for power drive systems, motor starters, power electron-
ics and their driven applications – Energy efficiency indicators
for power drive systems and motor starters
IEC/EN 61800-9-2:2017
Insulation coordination for equipment within low-voltage sys-
tems. Part 1: Principles, requirements and tests.
IEC 60664-1:2007
Standard for Safety, Adjustable Speed Electrical Power Drive
Systems – Part 5-1: Safety Requirements – Electrical, Thermal
and Energy
UL 61800-5-1: 1st edition
Adjustable speed drivesCSA C22.2 No. 274-17
Note: US variants 343A-2 and 396A-2 have not been verified to comply with CSA,
CE or IEC directives or any standard other than UL 61800-5-1: 1st edition.
Markings
These markings are attached to the drive:
CE mark
Product complies with the applicable European Union legislation. For fulfilling
the EMC requirements, see the additional information concerning the drive EMC
compliance (IEC/EN 61800-3).
354 Technical data
To Next Page
Loading...
