ABB ACS580 Series - Terms and Abbreviations

SeeTask
IEC: Connecting the control cables (page 159)
Connect the control cables.
North America: Connecting the control
cables (page 202)
Installation checklist (page 237)
Check the installation.
ACS580 standard control program firmware
manual (3AXD50000016097 [English])
Commission the drive.
Terms and abbreviations
DescriptionTerm
Standard assistant control panelACS-AP-S
Basic control panelACS-BP-S
Conducts the surplus energy from the intermediate circuit of the
drive to the brake resistor when necessary. The chopper operates
when the DC link voltage exceeds a certain maximum limit. The
voltage rise is typically caused by deceleration (braking) of a high
inertia motor.
Brake chopper
Dissipates the drive surplus braking energy conducted by the brake
chopper to heat
Brake resistor
CAIO-01 optional bipolar analog input and unipolar analog output
extension module
CAIO-01
The capacitors connected to the DC linkCapacitor bank
Bipolar analog IO extension moduleCBAI-01
Configuration adapterCCA-01
Communication adapter moduleCDPI-01
115/230 V digital input extension moduleCHDI-01
Multifunction extension module (external 24 V AC/DC and digital
I/O extension)
CMOD-01
Multifunction extension module (external 24 V AC/DC and isolated
PTC interface)
CMOD-02
The part in which the control program runs.Control unit
Multifunction extension module (external 24 V and ATEX/UKEX-cer-
tified PTC interface)
CPTC-02
DC circuit between line-side converter and motor-side converterDC link
Energy storage which stabilizes the intermediate circuit DC voltageDC link capacitors
Mounting platform for control panel (flush mounting)DPMP-01
Introduction to the manual 31