ABB ACS880 N5700 Series - Page 445

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
User Position CW1 bit
0 / int32
Selects a source that enables/disables the axis (and
start) commands when 20.3 Ext1 in1 source is set to
Position CW enable. This command is always
level-triggered.
Enable sel74.20
00.False
11.True
2Digital input DI1 (10.2 DI delayed status, bit 0).DI1
3Digital input DI2 (10.2 DI delayed status, bit 1).DI2
4Digital input DI3 (10.2 DI delayed status, bit 2).DI3
5Digital input DI4 (10.2 DI delayed status, bit 3).DI4
6Digital input DI5 (10.2 DI delayed status, bit 4).DI5
7Digital input DI6 (10.2 DI delayed status, bit 5).DI6
8Digital input/output DIO1 (11.2 DIO delayed status, bit
0).
DIO1
9Digital input/output DIO2 (11.2 DIO delayed status, bit
1).
DIO2
10Bit 0 of 74.7 User Position control word 1.User Position CW1
bit 0
11Bit 1 of 74.7 User Position control word 1.User Position CW1
bit 1
12Bit 2 of 74.7 User Position control word 1.User Position CW1
bit 2
13Bit 3 of 74.7 User Position control word 1.User Position CW1
bit 3
14Bit 4 of 74.7 User Position control word 1.User Position CW1
bit 4
15Bit 5 of 74.7 User Position control word 1.User Position CW1
bit 5
16Bit 6 of 74.7 User Position control word 1.User Position CW1
bit 6
17Bit 7 of 74.7 User Position control word 1.User Position CW1
bit 7
See Terms and abbreviations (page 130).Other [bit]
User Position CW1 bit
1 / int32
Selects the source of an external axis fault reset signal.
The signal resets an axis fault if the cause of the fault
no longer exists. This command is always
edge-triggered.
For the selections, see 74.20 Enable sel.
Fault reset sel74.21
False / int32Selects the source of a jog signal (in the positive
direction).
This command is always level-triggered.
In case jogging is activated in both the positive and
negative directions, the one that was activated last
takes priority.
For the selections, see 74.20 Enable sel.
Jog forward sel74.22
Parameters 445