Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
False / int32Selects the source of a jog signal (in the negative
direction).
This command is always level-triggered.
In case jogging is activated in both the positive and
negative directions, the one that was activated last
takes priority.
For the selections, see 74.20 Enable sel.
Jog reverse sel74.23
User Position CW1 bit
4 / int32
Selects the source of a signal that activates the preset
functionality defined in 75.36 Preset position mode.
This command is always edge-triggered.
For the selections, see 74.20 Enable sel.
Set position sel74.24
- / int32Selects the source of a signal that activates homing.
Parameter 74.15 Position command trigger type defines
whether the command is edge-triggered or
level-triggered.
For the selections, see 74.20 Enable sel.
Homing sel74.25
False / int32Selects the source of a signal that activates the move
in velocity mode function. Parameter 74.15 Position
command trigger type defines whether the command
is edge-triggered or level-triggered.
For the selections, see 74.20 Enable sel.
Velocity sel74.26
User Position CW1 bit
6 / int32
Selects the source of a signal that activates the move
relative function. Parameter 74.15 Position command
trigger type defines whether the command is
edge-triggered or level-triggered.
For the selections, see 74.20 Enable sel.
Relative sel74.27
User Position CW1 bit
7 / int32
Selects the source of a signal that activates the move
absolute function. Parameter 74.15 Position command
trigger type defines whether the command is
edge-triggered or level-triggered.
For the selections, see 74.20 Enable sel.
Absolute sel74.28
False / int32Selects the source of a signal that activates or provides
the start command for the position index functionality.
Parameter 74.15 Position command trigger type defines
whether the command is edge-triggered or
level-triggered.
For the selections, see 74.20 Enable sel.
Position index sel74.29
- / int32Selects the path direction together with 74.31 Path
direction bit 1 sel. See 74.4 Position command status
1, bit 10. This command is always level-triggered.
For the selections, see 74.20 Enable sel.
Path direction bit 0
sel
74.30
False / int32Selects the path direction together with 74.30 Path
direction bit 0 sel. See 74.4 Position command status
1, bit 11. This command is always level-triggered.
For the selections, see 74.20 Enable sel.
Path direction bit 1
sel
74.31
False / int32Selects the source of a signal that activates the gear-in
function. Parameter 74.15 Position command trigger
type defines whether the command is edge-triggered
or level-triggered.
For the selections, see 74.20 Enable sel.
Gear in sel74.32
446 Parameters
To Next Page
Loading...
