ABB ACSM1 - Page 132

Parameters and firmware blocks
132
12.13 DI INVERT MASK FW block: DI (see above)
Inverts status of digital inputs as reported by 2.01 DI STATUS. For example, a value of 0b000100
inverts the status of DI3 in the signal.
0b000000…0b111111 DI status inversion mask.
12.14 DIO2 F MAX FW block: DIO2 (see above)
Defines the maximum input frequency for DIO2 when 12.02 DIO2 CONF is set to (2) Freq input.
The frequency signal connected to DIO2 is scaled into an internal signal (2.10 DIO2 FREQ IN) by
parameters 12.14…12.17 as follows:
3…32768 Hz DIO2 maximum frequency.
12.15 DIO2 F MIN FW block: DIO2 (see above)
Defines the minimum input frequency for DIO2 when 12.02 DIO2 CONF is set to (2) Freq input. See
parameter 12.14 DIO2 F MAX
3…32768 Hz DIO2 minimum frequency.
12.16 DIO2 F MAX SCALE FW block: DIO2 (see above)
Defines the value that corresponds to the maximum input frequency defined by parameter 12.14 DIO2
F MAX. See parameter 12.14 DIO2 F MAX.
-32768…32768 Scaled value corresponding to DIO2 maximum frequency.
12.17 DIO2 F MIN SCALE FW block: DIO2 (see above)
Defines the value that corresponds to the minimum input frequency defined by parameter 12.15 DIO2
F MIN. See parameter 12.14 DIO2 F MAX.
-32768…32768 Scaled value corresponding to DIO2 minimum frequency.
f
DIO2
(Hz)
12.14
12.16
12.17
12.15
2.10 DIO2 FREQ IN