ABB ACSM1 - Page 179

Parameters and firmware blocks
179
33.03 SUPERV1 LIM HI FW block: SUPERVISION (see above)
Sets the upper limit for supervision 1. See parameter 33.01 SUPERV1 FUNC.
-32768…32768 Upper limit for supervision 1.
33.04 SUPERV1 LIM LO FW block: SUPERVISION (see above)
Sets the lower limit for supervision 1. See parameter 33.01 SUPERV1 FUNC.
-32768…32768 Lower limit for supervision 1.
33.05 SUPERV2 FUNC FW block: SUPERVISION (see above)
Selects the mode of supervision 2.
(0) Disabled Supervision 2 not in use.
(1) Low When the signal selected by parameter 33.06 SUPERV2 ACT falls
below the value of parameter 33.08 SUPERV2 LIM LO, bit 1 of 6.14
SUPERV STATUS is activated. To clear the bit, the signal must
exceed the value of parameter 33.07 SUPERV2 LIM HI.
(2) High When the signal selected by parameter 33.06 SUPERV2 ACT
exceeds the value of parameter 33.07 SUPERV2 LIM HI, bit 1 of 6.14
SUPERV STATUS is activated. To clear the bit, the signal must fall
below the value of parameter 33.08 SUPERV2 LIM LO.
(3) Abs Low When the absolute value of the signal selected by parameter 33.06
SUPERV2 ACT falls below the value of parameter 33.08 SUPERV2
LIM LO, bit 1 of 6.14 SUPERV STATUS is activated. To clear the bit,
the absolute value of the signal must exceed the value of parameter
33.07 SUPERV2 LIM HI.
(4) Abs High When the absolute value of the signal selected by parameter 33.06
SUPERV2 ACT exceeds the value of parameter 33.07 SUPERV2 LIM
HI, bit 1 of 6.14 SUPERV STATUS is activated. To clear the bit, the
absolute value of the signal must fall below the value of parameter
33.08 SUPERV2 LIM LO.
33.06 SUPERV2 ACT FW block: SUPERVISION (see above)
Selects the signal to be monitored by supervision 2. See parameter 33.05 SUPERV2 FUNC.
Value pointer: Group and index
33.07 SUPERV2 LIM HI FW block: SUPERVISION (see above)
Sets the upper limit for supervision 2. See parameter 33.05 SUPERV2 FUNC.
-32768…32768 Upper limit for supervision 2.
33.08 SUPERV2 LIM LO FW block: SUPERVISION (see above)
Sets the lower limit for supervision 2. See parameter 33.05 SUPERV2 FUNC.
-32768…32768 Lower limit for supervision 2.