ABB DCS550 - Page 250

250
Signal and parameter list
3ADW000379R0501 DCS550 Manual e e
Signal / Parameter name
min.
max.
def.
unit
64.06 Add1 (adder 1, output)
Output of adder 1 in percent of
MotNomTorque (4.23).
Int. Scaling: 100 == 1 % Type: I Volatile: Y
-
-
-
%
64.07 Unused
Adder 2 provides two torque inputs. The sum of Add2 (64.13) can be written to other parameters by means of
Add2OutDest (64.08)
. Usually adder 2 is used to write on the load compensation for inertia and friction compensation.
Commissioning hint:
− Add2Cmd (64.11) releases Add2 (64.13). The output is forced to zero if the switch is open.
64.08 Add2OutDest (adder 2, destination of output value)
Index pointer to the sink for adder 2 output value. The format is
-xxyy, with: - = negate output value, xx =
group and
yy = index.
As default,
nothing is connected to the output.
Int. Scaling: 1 == 1 Type: SI Volatile: N
-9999
9999
0
-
64.09 Add2In1 (adder 2, input 1)
Source (signal/parameter) for adder 2 input 1. The format is
-xxyy, with: - = negate output value, xx = group
and
yy = index.
Default setting of 6230 equals
InertiaComp (62.30).
Int. Scaling: 1 == 1 Type: SI Volatile: N
-9999
9999
6230
-
64.10 Add2In2 (adder 2, input 2)
Source (signal/parameter) for adder 2 input 2. The format is
-xxyy, with: - = negate output value, xx = group
and
yy = index.
Default setting of 6334 equals
FrictionComp (63.34).
Int. Scaling: 1 == 1 Type: SI Volatile: N
-9999
9999
6334
-
64.11 Add2ReleaseCmd (adder 2, release command)
Source to
release / block adder2:
0 =
NotUsed constant 0; block adder 2
1 =
Auto depending on winder logic and winder macro, see WinderMacro (61.01), default
2 =
Release constant 1; release adder 2
3 =
WindCtrlWord according to WindCtrlWord (61.16) bit 15
4 =
DI1 1= release adder 2; 0 = block adder 2
5
- 23 see WriteToSpdChain (61.02)
Note:
Blocking adder 2 forces its output to zero
- Add2 (64.11) = 0.
Int. Scaling: 1 == 1 Type: C Volatile: N
NotUsed
1905Bit3
Auto
-
64.12 Unused
64.13 Add2 (adder 2, output)
Output of adder 2 in percent of
MotNomTorque (4.23).
Int. Scaling: 100 == 1 % Type: I Volatile: Y
-
-
-
%