11: CFM
z CCM sequence number: Enable or disable CCM sequence number. When enabled, a MEP transmits CCMs with
a sequence number that increases by one for each CCM. When disabled, a MEP transmits CCMs with a
sequence number set to zero.
z Note: A peer MEP should have sequence number enabled to allow a local MEP to perform CCM based packet
loss measurements.
z Primary VID: The Primary VLAN ID of the MEP. This is always one of the VLAN IDs assigned to the MEP's MA.
The value 0 indicates that either the Primary VLAN ID is that of the MEP's MA, or that the MEP's MA is
associated with no VLAN ID.
z CCM and LTM priority: The priority parameter for CCMs and LTMs transmitted by the MEP (default value: the
highest priority, i.e. the highest numerical value allowed to pass through the Bridge Port for any of this MEP's
VLAN IDs).
z Lowest priority defect alarm: The lowest priority defect alarm specifies the lowest priority defect that is allowed to
generate a Fault Alarm.
z Fault notification alarm time: The time that defects must be present before a Fault Alarm is issued.
z Fault notification reset time: The time that defects must be absent before resetting a Fault Alarm.
z Enable fault propagation: Use this MEP's status in fault propagation.
z Propagate on port: Specify the EVC client port to which the MEP status should be propagated. That port should
be also configured to perform EVC fault propagation for this parameter to take effect.
To Next Page
Loading...
