Step 3: Press SELECT. The message window displays the current
brightness value for red.
Step 4: To display the brightness filter submenu, press and hold
MENU and SELECT at the same time. After the PCR II Plus
beeps once, release only MENU. Listen for a second beep,
and release SELECT.
Step 5: Enter the three brightness numbers like this:
• Press PREVIOUS or NEXT to change the red setting.
• Press MENU to access the green setting.
• Press PREVIOUS or NEXT to change the green setting.
•
Press
MENU
to
access
the
blue
setting.
• Press PREVIOUS or NEXT to change the blue setting.
• Press SELECT to return to the main menu.
Step 6: To enter the contrast filter settings, press MENU to again ar-
rive at the SET BRIGHTNESS display.
Step 7: Press SELECT.
Step 8: To display the contrast filter submenu, press and hold
MENU and SELECT at the same time. This time, release only
SELECT after the first beep, and release MENU after the sec-
ond beep.
Step 9: Enter the contrast filter numbers following the same proce-
dure in Step 5.
Recurring BATTERY! ERROR Messages
If the message BATTERY! ERROR appears again after power up, indi-
cating a battery failure, contact an authorized service representative.
Troubleshooting • 7-9
To Next Page
