Setting Device Addresses
Each device on the chain is assigned a unique address that specifies a
location or destination of information.
Use the controls and message window on the PCR II Plus front panel
to set the film recorder's device address.
Guidelines
Before you set the PCR II Plus device address, note these guidelines:
• The default SCSI ID setting is one (1).
• The default GPIB address is two (2).
• When using GPIB communication between your host computer and
the PCR II Plus, the GPIB address must be an even number.
• When setting the SCSI address, you can choose an address between
zero (0) and six (6). If you are connecting to a Macintosh, do not set
the PCR II Plus address to 0. This SCSI device address is reserved
for the hard drive and CPU of the Macintosh.
• Know the addresses of all the other devices on your chain. Do not
assign a previously used address to the PCR II Plus.
2-12 • PCR II Plus User Guide
To Next Page
Loading...
