Computer Locks Up on Large image Files
Some host computers may not have enough memory to process large
image files. You may have to reconfigure your system to obtain proper
operation.
If
this
does
not
work,
contact
your
Agfa
dealer
for
additional
support.
35mm Film Will Not Load
Make sure that the power switch on the 35mm camera is set to the ON
position. Also check that the camera connector is properly seated.
System Locks Up When You Touch Film Module
The system may lock up if there is a static discharge between you and
the film module when you touch it. Your body can accumulate a size-
able static charge if the working environment has very low relative hu-
midity, or if PCR II Plus is located in a carpeted area.
The
easiest
way to
lower
the
risk
of a
static
discharge
to the
film
mod-
ule is to first touch PCR II Plus outer cabinet. The cabinet is electri-
cally grounded and can dissipate most static discharges that your body
generates.
If the
problem
persists,
invest
in a
high-quality,
anti-static
floor
mat
for the immediate area in which the PCR II Plus is located. Anti-static
mats are available from computer supply houses and usually have a
grounding wire that connects to the wall outlet.
Troubleshooting • 7-5
To Next Page
Loading...
