Frame Count
The SET
FRAME
COUNT
#
command
sets
the
frame
number
that
ap-
pears in the READY message in the message window. You can set the
frame number to any value between zero and 255. This function does
not advance the film in the 35mm module.
Use this command if you forget to execute the LOAD FILM function or
the frame number in the message window does not match the actual
frame that the camera is ready to expose.
Follow this procedure:
Step 1: Press MENU once then PREVIOUS or NEXT until you reach
the SET FRAME COUNT# selection.
Step 2: Press SELECT to display the frame count submenu. The dis-
play reads FRAME# nnn, where nnn is some number be-
tween zero and 255.
Step 3: Press NEXT to reach the desired number. Select 1 or greater
for the counter to begin recording the number of frames that
you have imaged.
Step 4: Press SELECT to choose your frame number and exit the
frame counter submenu.
Step 5: Press MENU to return to the ready condition.
Film Control • 4-5
To Next Page
Loading...
