Film Guidelines
Use the same film type.
Changing back and forth among different types of film can cause con-
fusion, discarded film runs, and wasted time and money.
Use film from the same batch or lot.
Use film with the same emulsion number whenever possible. The most
consistent results are obtained from the same film batch. Check the
film batch data printed on the side of the film box.
Store film under recommended conditions.
Follow the film manufacturer's recommendations for storing your film.
These recommendations include the temperature and humidity condi-
tions best suited to the film.
Use the same lab to process all your film.
This minimizes the variables in processing equipment and supplies.
Always Verify the Film Type
Before
you
modify
the
brightness
or
contrast
values,
make
sure
that
the film type you specified at the PCR II Plus control panel matches the
type of film that is loaded in the camera module. If not, use the SET
FILM TYPE function to select the correct film type.
Changes and Default Settings
Changes to the brightness, contrast or repeat values are saved as the
new
default
settings
for the
currently
specified
film
type.
FILM
SELECT
commands from Agfa and third-party rasterizers will load these cus-
tomized settings.
Use the RESET DEFAULTS function to restore the original settings
provided in the film recorder firmware.
Color Balance • 6-15
To Next Page
Loading...
