Loading Film
The procedure to load a 100 foot (30 meter) bulk roll of film into the
35mm Bulk Load Cassette consists of these major steps:
1. Load the feed magazine.
2. Thread the film through the body of the module.
3. Thread the film into the take-up magazine.
Figure 3 on page 8 identifies the parts of the module and shows the
film path.
Loading the Feed Magazine
Follow this procedure to load the feed magazine:
Step 1: Remove the feed magazine from the camera module.
• Before you begin loading film, open the empty feed mag-
azine and get acquainted with the parts of the assembly.
Caution:
Perform steps 2 through 7 in a film changing bag
or in a darkroom.
Step 2: Unwrap the bulk roll of film. Place the film and core onto the
plastic film spool.
• Bulk rolls of 35mm film are wound around a small plas-
tic core.
• The plastic film spool comes with the camera module and
is stored inside the feed magazine.
Step 3: Rotate the core until the spool alignment screw lines up with
the slot in the core.
6 • PCR II Plus 35mm Bulk Load Camera Module
To Next Page
