AGFA PCR II Plus - Code 92 (PC): GPIB Interface Error; Code 92 (Macintosh): SCSI Interface Error; Code 93: CRT Brightness or Contrast Calibration Error

Code 92 (PC): GPIB Interface Error
Secondary Code: 00
When an operator attempted to start a local test pattern, the film re-
corder was unable to put the GPIB interface into the local mode of op-
eration. The film recorder did not initiate a test pattern.
Secondary Code: 0l
The GPIB experienced a handshake error while transmitting or receiv-
ing data. Check your connections.
Code 92 (Macintosh): SCSI Interface Error
Secondary Code: 00
The film recorder has detected a parity error during data transfer from
the host.
Secondary Code: 01
SCSI Controller fault.
Code 93: CRT Brightness or
Contrast Calibration Error
Secondary Code: 00, 0l
Code 00 indicates that the CRT beam is too bright.
Code 01 indicates that the CRT beam is too dim. If the film recorder is
unable to maintain proper CRT intensity, contact your Agfa service rep-
resentative.
Appendix • A-17