AGFA PCR II Plus - Reset Defaults; The Pcriiplus Beeper

Reset Defaults
This function restores the factory-set default look-up table, brightness,
contrast and repeat values for the currently selected film type. Any cus-
tomized values previously stored for this film type are replaced by the
default settings.
The PCR II Plus Beeper
The PCR II Plus emits various sounds to indicate different operating
conditions. The following list describes these sounds and their mean-
ings:
• Solid one-half second beep: Completion of a reset.
• Four short beeps: The PCR II Plus has successfully recorded an
image.
• Single short beep: With an END OF FILM message on the front
panel display, indicates that the PCR II Plus is out of film. Repeats
approximately once every five seconds.
• Two-second warbled beep: Indicates an error. Repeats approxi-
mately every five seconds. The alarm stops when you reset the film
recorder. SRQ is serviced from the host (GPIB version) or a RE-
QUEST SENSE command is sent from the initiator or host (SCSI
version).
Start-up • 3-11