Unloading Film
Before you remove an exposed roll of film from the 35mm camera mod-
ule,
follow
this
procedure
to
execute
an
UNLOAD
FILM
command:
Step 1: Press MENU once, then press PREVIOUS or NEXT until the
message window displays UNLOAD FILM SELECT FUNC-
TION.
Note: The UNLOAD FILM command appears only
after you have selected the LOAD FILM function.
Step 2: Press SELECT to execute the UNLOAD FILM command. This
resets the frame counter to zero (#0).
Step 3: Rewind the film using the instructions in the corresponding
camera module section.
Step 4: Open the camera back and remove the used film. For proce-
dures, refer to the section on the corresponding camera
module.
Step 5: Press MENU once to return to the ready condition.
Film Control • 4-3
To Next Page
Loading...
