Set Device Address Procedure
To set the device address, use the front panel controls to access the de-
vice address function.
Follow this procedure to set the address:
Step 1: Make sure that the PCR II Plus is ON and ready and that you
know the device addresses of all other peripherals being used
on the chain with your film recorder.
Step 2: Press MENU once, then NEXT or PREVIOUS until the mes-
sage window displays SET GPIB ADDRESS or SET SCSI AD-
DRESS. The selection that appears depends on the current
communication mode.
Step 3: Press SELECT once. The message window displays the cur-
rent device address (e.g., GPIB 2 or SCSI 1).
Step 4: To change the address setting, press NEXT or PREVIOUS
until the message window displays the address you want to
use.
• If you are using SCSI communication, you can select a
number from 1 to 6 for the address.
• If you are using GPIB communication, you can select an
even number from 2 to 30 for the address.
Step 5: Press SELECT to choose the new address.
Step 6: Press MENU to return to the ready menu.
Installation • 2-13
To Next Page
Loading...
