Repeats and Brightness
As the CRT brightness level becomes lower, the time it takes to expose
the film increases proportionally. Reduced CRT brightness also reduces
the CRT spot size. This gives better image quality. Increase the num-
ber of repeats to compensate for lower brightness.
Setting the Repeat Value
To set the number of repeats:
Step 1: Turn on the PCR II Plus and specify the resolution (2K or 4K)
and the film type.
Step 2: Press MENU and then NEXT or PREVIOUS until the message
window displays SET REPEAT VALUE SELECT FUNCTION.
Step 3: Press SELECT to enter the repeat values submenu. The dis-
play reads RED 0.
Step 4: Press NEXT or PREVIOUS to scroll through the settings. You
can specify a value from 0 to 10.
Step 5: Press SELECT when the message window displays the repeat
value that you want to use.
Step 6: Press NEXT to display the current repeat value for green.
Step 7: Repeat steps 4 and 5 to change the repeat value for green.
Step 8: Press NEXT to display the current repeat value for blue.
Step 9: Repeat steps 4 and 5 to change the repeat value for blue.
Step 10: Press MENU to return to the ready condition.
6-12 • PCR II Plus User Guide
To Next Page
Loading...
