Set Film Type
The SET FILM TYPE function enables you to specify which type of film
you are using.
To use this function, follow these steps:
Step 1: Attach the camera module to the film recorder.
Step 2: Press MENU once, then NEXT or PREVIOUS until the display
reads SET FILM TYPE SELECT FUNCTION.
Step 3: Press SELECT. The message window displays the currently
selected film type.
Step 4: Press NEXT or PREVIOUS to scroll through a list of the other
supported film types. For example, if you are using the
35mm module, your choices are:
EKTA ASA 100 PRO
AGFA RS100 PLUS
AGFA OPTIMA 125
VERICOLOR 3S
USER FILM 1
USER FILM 2
Step 5: When the message window displays the film type you are
using, press SELECT. The film recorder does the following:
• Loads the default look-up table for the specified film type.
• Loads the brightness, contrast and repeat values last set
at the front panel controls for the specified film type.
• Calibrates the CRT brightness levels.
Step 6: Press MENU to return to the READY message.
4-6 • PCR II Plus User Guide
To Next Page
Loading...
