AGFA PCR II Plus - Threading Film through the Module Body

Threading Film Through the Module Body
Figure 3 identifies the parts of the camera module and shows the
film path.
Follow these steps to thread the film through the body of the module:
Step 1: Feed the entire leader into the camera body.
Step 2: Thread the film through the body so that it follows this path:
• Under the film guide.
• Under the pressure plate.
• Up and between film guide roller 3 and the drive sprocket.
Make sure that:
• The edge of the film presses against the end of film sen-
sor switch.
• The sprocket holes in the film line up with the teeth on
the drive sprocket.
Step 3: Remove the take-up magazine from the camera module.
Step 4: Feed the film up through the light trap so that at least 6
inches (15 cm) protrude up from the camera body.
Step 5: Make sure the film is threaded correctly through the camera
body:
• Examine the film path. Make sure that the film is snug
against the film guide rollers and the drive sprocket.
• Press down on the pressure plate.
Step 6: Press the jog forward button a few times to advance a few
frames and make sure that the film is moving properly.
Step 7: Close the camera door.
PCR II Plus 35mm Bulk Load Camera Module • 9