Resetting the PCR II Plus
Reset PCR II Plus if an error condition causes it to cease operating
properly. Press the RESET switch on the front panel.
When Reset Occurs
The system resets:
• During power-up.
• When you press the reset switch on the front panel. This is a warm
reset.
• When the film recorder receives reset command from the host com-
puter through the SCSI or GPIB communication interface.
• After you change the position of the GPIB/SCSI switch and the
READY message is displayed in the message window.
• After the camera module cable is connected or disconnected.
• After the PCR II Plus receives a Select Resolution with Reset com-
mand.
Start-up • 3-9
To Next Page
