RESET DEFAULTS
SELECT FUNCTION
Reloads the default brightness, contrast and repeat values for the cur-
rently selected film type.
SAVE LUT
SELECT FUNCTION
Transfers the look-up table currently active in the PCR II Plus into the
default memory location for the installed camera module and film type.
SET PACING
SELECT FUNCTION
Enables you to adjust imaging speed to better match rasterizer data
transfer rates. See the section Pacing Control in Chapter 5 for more
information.
SET GPIB ADDRESS
SELECT FUNCTION
Sets the GPIB device address.
SET SCSI ADDRESS
SELECT FUNCTION
Sets the SCSI device address.
SET BRIGHTNESS
SELECT FUNCTION
Opens a submenu that enables you to view and/or change the brigh-
tness value for each of the three colors. Changes to brightness values
become the defaults for the selected film type until you reset the de-
faults. See the section Brightness Control in Chapter 6 for more infor-
mation.
SET CONTRAST
SELECT FUNCTION
Opens a submenu that enables you to view and/or change the contrast
value for each of the three colors. Changes to contrast values become
the defaults for the selected film type. See the section Contrast Control
in Chapter 6 for more information.
Start-up • 3-7
To Next Page
Loading...
