COMMAND BYTE
The PCR II Plus has received an unrecognized command. Check your
system and the film recorder connectors. If the error persists, call for
service.
DATA BYTE
PCR II Plus has received unrecognized data. Check your host system
and the film recorder connectors. If the error persists, call for service.
INTERNAL MEMORY
Turn off the film recorder and wait 30 seconds. Turn the film recorder
back on and retry the image. If the error persists, call for service.
GPIB INTERFACE
The PCR II Plus detected a communication problem while using the
GPIB communication interface. Check your connections. If the error
persists, call for service.
SCSI INTERFACE
The PCR II Plus detected a communication problem while using the
SCSI communication interface. Check your connections. If the error
persists, call for service.
BRT CAL
There is a problem with the CRT. Call for service.
CNT CAL
There is a problem with the CRT. Call for service.
MODULE FAULT
A function was requested that requires the use of the camera module,
but no
module
was
detected.
Install
the
camera
module
on the
film
re-
corder's front panel. Make sure that the camera connector is securely
plugged in. If problems persist, call for service.
FILTER WHEEL
There is a problem with the filter wheel. If the error persists, call for
service.
Troubleshooting • 7-3
To Next Page
Loading...
