171
A Accessories and platepads
Installing and configuring the Peltier Thermal Station
Bravo Platform User Guide
Note: The accessory cable is color-coded to match the card installed in the
STC or MTC.
b Connect the STC or MTC Controller power and communication cables. See the
Inheco user documentation for details on how to connect the STC or MTC.
c Press the STC or MTC Controller power switch to the on (|) position.
Figure MTC Controller (front and back views)
After installing the accessory, you configure it in the Bravo profile, establish
communication, and set the teachpoint for the location.
Related information
For information about… See…
Configuring the Peltier Thermal Station
in the Bravo profile and setting the
teachpoint
“Setting up thermal and shaking stations
(Inheco controller)” on page 159
Using the accessory in a protocol VWorks Automation Control User Guide
To Next Page
Loading...
Need help?
General
