Agilent Technologies FieldFox N9912A - Page 79

SA (Spectrum Analyzer) Mode 79
How to use the Antenna/Cable Editor
 Press New then Yes to clear all data from the existing Antenna or Cable table
and reset header information to default settings.
 Then Edit Antenna or Edit Cable to open the Antenna / Cable Editor.
 Then use the ▲|▼ arrows to select a field,
o When editing Header information, press Edit then modify the selected field
using the FieldFox labeler.
o When editing Frequency/Value pairs, enter numbers using the numeric
keypad, and a frequency suffix when necessary. Then Enter. Positive Values
are interpreted as LOSS for both Cable Loss and Antenna Gain Factor.
Learn more about “How the Freq/Value pairs are applied” below.
 Optionally choose from the following:
o Previous / Next Page Quickly scrolls through pages of Freq/Value data.
o Add Data Add a blank Freq/Value pair to the table,
o Delete/Clear then:
o Delete Line Remove the selected Freq/Value pair from the table.
o Clear All then Yes Remove all Freq/Value pairs from the table and resets
header information to default settings.
When the table edits are complete
 Press Done to closes the Antenna/Cable Editor.
 Press Save Antenna or Save Cable to saves your changes to the specified
Storage Device. Enter a filename using the FieldFox labeler (learn how on page
151). Learn more about Antenna and Cable files below.
 Press Recall Antenna or Recall Cable to load an Antenna or Cable file from
the specified Storage Device.
 Storage Device Changes the device used to save or recall files. Choose from
Internal (default setting), USB (must be connected) or SD card. This is a
different setting from the Save/Recall Storage Device setting.
About the Antenna/Cable header fields
 Description: Enter a description for the antenna or cable correction table. This
is NOT the filename used to save the file.
 Antenna Unit: Units in which the measurement will be displayed. Select
NONE (default setting) to select from standard SA Units on the Scale menu.
Learn how on page 74.
Choose from: dB μV/m - (dB micro Volts per meter), dB μA/m - (dB micro
Amps per meter), dBG (gauss), dBpT (tesla).
 Freq Interpolation: Set to LINear and can NOT be edited.