System Related Operation 4
Utility Menu Summary
U3606A User’s and Service Guide 115
7 Repeat step 6 for all errors in the error queue.
8 After reading all errors, press Shift > Exit to exit the utility menu.
9 The error queue is automatically cleared when all errors have been read
(primary display shows “nonE”).
Reading the program code revision
The following procedure shows you how to read the program code revision
from the front panel.
1 To access the utility menu, press Shift > Utility.
2 The first utility menu item (Error) will be shown in the upper
secondary display.
3 Press . The next menu item (P.CodE) will be shown in the upper
secondary display.
4 Press or to cycle between the interface board (IOb), source board
(Sb), and measurement board (Mb) program code revisions.
5 After reading the program code revisions, press Shift > Exit to exit the
utility menu.
See Chapter 9, “List of Error Messages,” starting on page 257 for a list of
all error numbers and their respective message string.
To Next Page
Loading...
