System Related Operation 4
Utility Menu Summary
U3606A User’s and Service Guide 127
Enable data hold
The following procedure shows you how to enable the data hold mode.
1 To access the utility menu, press Shift > Utility.
2 The first utility menu item (Error) will be shown in the upper
secondary display.
3 Press or until the menu item “rHoLd” is shown in the upper
secondary display.
4 Press or to change the refresh hold variation to “OFF”. See
“Editing values” on page 110 for more information.
5 Press Shift > Save to save or press Shift > Exit to exit the edit mode
without saving.
6 Press Shift > Exit to exit the utility menu.
• To enable refresh hold again, enter a value for the refresh hold
variation.
• The threshold (nH) is not applicable in the data hold mode.
To Next Page
Loading...
Need help?
General
