Agilent Technologies U3606A User Manual

List of Error Messages 9
Error Messages
U3606A User’s and Service Guide 263
Calibration errors
The following errors indicate failures that may occur during a calibration.
645 Constant Current 0.2V/10kohm or amplified 11 error
646 Constant Current 0.8V/100kohm or amplified 11 error
647 Constant Current 0.8V/1.1Mohm or amplified 11 error
Table 9 - 6 List of self-test errors (continued)
Error code Error message
Table 9 - 7 List of calibration errors
Error code Error message
701 Cal security pads short
703 Invalid secure code
705 Cal aborted
707 Cal signal measurement out of range
708 Cal signal frequency out of range
709 EEPROM write failure
720 Cal DCV offset out of range
721 Cal DCI offset out of range
722 Cal RES offset out of range
723 Cal CAP offset out of range
726 Cal RES open out of range
742 Cal checksum failed, DCV corrections
743 Cal checksum failed, DCI corrections
744 Cal checksum failed, RES corrections
745 Cal checksum failed, ACV corrections

Agilent Technologies U3606A Specifications

General

Brand	Agilent Technologies
Model	U3606A
Category	Multimeter
Language	English