System Related Operation 4
Utility Menu Summary
U3606A User’s and Service Guide 123
6 Press or to change the ramp signal amplitude end position. See
“Editing values” on page 110 for more information.
7 Press or until the cursor is position on the ramp signal number
of steps. Press or to change the number of steps for the ramp
signal to increment from zero to the amplitude end position. See
“Editing values” on page 110 for more information.
8 After configuring the ramp signal parameters, press Shift > Save to save
or press Shift > Exit to exit the edit mode without saving.
9 Press Shift > Exit to exit the utility menu.
Amplitude end position
(NN.NNN V or N.NNNN A)
Number of steps
(NNNNN)
Ramp signal rangeCV/CC ramp signal parameters
• The increment of each step in the ramp signal will be the amplitude end
position divided by the number of steps. For example, a 15 V amplitude
end position divided by 100 steps gives an increment of 0.15 V per step.
• The ramp dwelling time selected will be fastest of the instrument
output capability. (Typically ~300 ms per step.)
To Next Page
Loading...
